Description
Designed with carpenters in mind, but offering enough storage solutions for several trades, this mid-sized tool belt is well suited for both interior and exterior work. It’s small enough to maneuver while doing interior work yet large enough to hold plenty of tools and fasteners for jobs that require more storage.
Carpenter Tool Bag: Tape pouch, 5 tool slots in main pouch-three along inside back and two inside front, single outside lower pouch with tool slot, rear tool loop. Pencil/utility combo up front with three small slots and one deep pocket. Overall length is approximately 14″. Also comes with a hammer sleeve.
Carpenter Fastener Bag: Tape pouch with 4 interior 1″ wide elastic nail set slots, speed square slot in main pouch with wide tool slot below, lower fastener pouch with slot, two front tool pockets, 2 stacked rear tool slots and a reinforced bar sleeve on the underside of the bag. Overall length is approximately 15″.
To ensure you get the belt that will offer you the most flexibility, it’s important that you read and follow these instructions. DO NOT base your choice on your pants size. Take a string or tape measure and measure snugly where you plan to wear your tool belt. Belts are typically worn on the hips. This area tends to be wider than where your pants sit. Keep in mind your working conditions. If you work outside in all seasons, layers will increase your circumference.
Our belts have around four or five inches of flexibility for the best fit. This is more than enough for most people. For an optimal fit, there should be 2″ to a max of 6″ of open space between your belt ends. For instance, if your measurement is 36”, you should go with a MD belt which will leave about 3” of open space. Keep in mind, if you prefer your bags to sit further back, order on the small side.